LUMIX S1R II Tether Setup Guide (44Mp Pdaf L-Mount)
The Panasonic LUMIX S1R II (44MP PDAF L-mount, released 2025) is fully supported by LUMIX Tether v2.10 and newer. This guide walks through the cleanest USB-C, LAN and Wi-Fi tether setup, what to expect from Live View, and the few model-specific quirks that trip people up.
What you need
- LUMIX S1R II with the latest firmware
- LUMIX Tether v2.12 — grab it from the streaming setup.
- USB 3.2 data-grade USB-C cable (not a charge-only cable)
- Windows 10/11 or macOS 12–15
USB-C tether (recommended)
On the S1R II, open Menu → Setup → IN/OUT → USB Mode → PC (Tether). Plug the cable into the camera's USB-C port and into a USB 3.x port on the laptop. Launch LUMIX Tether — the S1R II appears in the device list within 2–3 seconds. Click Live View and you're shooting.
LAN tether
The S1R II supports Gigabit Ethernet via the optional USB-C adapter (or natively on box bodies). Set a static IP in Wired LAN Settings, match it in LUMIX Tether's network dialog. LAN is mandatory if you want to drive multiple S1R II bodies for multicam.
Wi-Fi tether
Slowest path but cable-free. Use the camera's 5 GHz mode where available — 2.4 GHz drops Live View frames in busy studios.
Direct Save and RAW workflow
Set Settings → Save Destination in LUMIX Tether to a folder Capture One or Lightroom is watching. Frames land as RAW + JPEG within ~1 second of capture on USB 3.x.
Common S1R II gotchas
- If Live View is black, the camera's HDMI output is set to "External Recorder" — switch to "Tether/Monitor."
- Close LUMIX Sync on your phone first — only one remote session at a time.
- V-Log shows greyed-out live view; that is correct — apply a LUT in OBS or your NLE.
More guides
Run into issues? troubleshooting guide. how to tether. keyboard shortcuts.